How To Put Garage Floor Tiles
Garage floor tiles – Garage floor tiles has recently taken the tile as a versatile remodeling medium. Tiles are durable and easy to clean, making them ideal for covering a surface that will receive heavy wear and moisture, such as a garage floor. Tiles also works well because they can be installed directly over an unfinished floor, such as the typical cement floor in a garage. This makes the tiles a great way to add a bit of value and beauty to your garage.
Remove all appliances, furniture and all floor coverings that may be in the garage floor tiles. Sweep the floor thoroughly to remove any residue. Measure the width and length of the garage floor tiles. Multiply these two numbers to find the area of the room. Buy as many pieces as you will have to cover the space in the garage floor tiles. Also buy an additional 10 to 15 percent more tiles than you will need to take account of damage to the tiles during shipping or installation. Snap a chalk line across the width of the garage. Use the T-square to ensure it is perfectly perpendicular to the wall. Snap second line, the length of the garage by means of the T-square to ensure that it is also perpendicular to the wall. These intersecting lines will be your guide.
22 Photos Gallery of: How To Put Garage Floor Tiles
Mix the thin, there mortar according to the instructions on the package. Only mix as much thin set that you can spread in a half hour. If the thin, dries out it will lose its adhesiveness. Spread the thin set with a trowel covering the space of several tiles. Use of intersecting chalk lines as a guide, place the first tile. Apply even pressure with both hands to push the air out of the grooves in the notch tile made of thin set mortar. Add plastic tile spacers around each side of the garage floor tiles. Continue spread mortar and marketing tiles until you reach the end of the row . You may need to cut the tiles to make them fit at the end of rows or around fixtures.
To make straight cuts, use the wet tile saw. Select the tile where you want to cut it, and slowly and gently push it into the rotating wet leaves. To make curves to fit around drains or fixtures, only use tile scriber to etch a line into the tile along the path. Then gently use tile nippers to break small pieces off the tile until only the curve you need is back. Add the rest of the tiles and allow the thin set mortar to set according to the instructions on the package. Remove the spacers from between the garage floor tiles. Mix the grout according to the instructions on the package. Use rubber trowel to spread the grout into the spaces between the tiles. Wipe the excess grout with a damp cloth. Allow grout to set according to the instructions on the package, and you’re ready to use your new garage floor tiles.Tags: locking garage floor tiles, chocolate brown floor tiles